Free shipping on your first order over $5000 – use code TeamUSA at checkout!

Hobart  |  Warewash  |  SKU: BDSLRET-HTSDOM

Hobart BDSLRET-HTSDOM Warewash Undercounter Dishwashers

$18,277.74
Expected delivery date of , to your door
if ordered within hours and minutes
Not Shipping to ?
More Delivery Options

Documents

Reach out via chat, email, or phone—we're here to help make sure it's the right fit for your kitchen. Contact us for more information.

Description

CLeN Series All-Electric Blower-Dryer Accessory

Left-to-Right Operation · 600 V / 60 Hz / 3-Phase

Engineered exclusively for Hobart CLeN conveyor dishwashers, this blower-dryer bolts directly to the clean end of your warewasher and drives a high-velocity curtain of heated air across the conveyor – no manual towel-drying, no waiting, and no bottle-neck at the unload table.

Why you’ll love it

  • Rapid, spot-free drying with a positive-pressure air curtain.
  • Quiet 2 H.P. direct-drive industrial blower delivers high performance at a low sound level.
  • 10 kW Incoloy® electric heater with thermostatic control and independent over-temperature protection.
  • 33 in (838 mm) stainless-steel drying chamber – built to the same rugged standard as your Hobart warewasher.
  • Baffles below the conveyor recirculate air, minimising heat loss and protecting the operator at the discharge table.
  • Single-point, three-phase electrical connection simplifies installation.
  • Factory-matched “Dual-Drive” conveyor pawls couple seamlessly to CLeN machines – no field adaptation required.

Performance at a glance

Direction of travel Left → Right
Electrical spec 600 V / 60 Hz / 3-Phase
Rated amps 12.6 A
Minimum supply circuit 20 A
Maximum protective device 20 A
Heating capacity 10 kW electric (3 × 3.3 kW elements)
Blower motor 2 H.P. direct drive
Airflow 200 – 400 CFM
Chamber length 33 in (838 mm)
Vent connection 4 in × 16 in (inside), 400 CFM exhaust

Installation essentials

  • Mounts with nineteen (19) ¼-20 × ⅝ in stainless-steel bolts to the wash chamber – foam gasket supplied.
  • Requires a single three-phase connection; control circuit is factory-wired to operate only when the dishwasher pumps are running.
  • Provide a 4 in × 16 in vent stack capable of 400 CFM; do not install under a canopy hood.
  • Drain connection in dryer tank: 1 in FPT.
Heads-up: Canopy (type I or type II) hoods cannot be used above the blower-dryer. Ensure adequate clearance and dedicated venting as shown in the installation drawings.

Compatible CLeN models

CL44eN · CL54eN · CL64eN · CLP/CLC series (66 in & 76 in) · CLP/CLC series (86 in) – Left-to-Right configuration only.

Specifications subject to change without notice as part of Hobart’s continuous product improvement policy.

Features & Specs

Manufacturer

Hobart

Brand_name

Warewash

Specifications

Blower Dryer, Steam, L - R, 600v/60/3-ph, Higher Than Standard, Domestic