Hobart BDSLRAL-STDDOM Warewash Undercounter Dishwashers
Hobart BDSLRAL-STDDOM Warewash Undercounter Dishwashers is backordered and will ship as soon as it is back in stock.
Documents
Related Searches
Reach out via chat, email, or phone—we're here to help make sure it's the right fit for your kitchen. Contact us for more information.
Description
Hobart Steam Blower-Dryer – CLeN Series (Left-to-Right, 200-240 V / 50 Hz / 3-Ph)
High-velocity drying module for Hobart CLeN conveyor dishwashersUpgrade your CLeN warewasher with Hobart’s stainless-steel Steam Blower-Dryer and send every rack out bone-dry, table-ready and spotless. A 2 H.P. direct-drive blower forces room air across a steam coil, delivering a controlled curtain of heated air that strips moisture from dishes, trays and utensils—without the noise, energy waste or floor-space penalties of bulky add-ons.
Key advantages
- Stainless-steel 33 in. chamber built to outlast the dishwasher itself.
- Positive, high-velocity air flow dries even recessed areas and plastics.
- Ultra-quiet industrial blower (2 H.P.) keeps the dishroom conversation-friendly.
- Low steam demand—just 55 lb/hr at 20 psi—for outstanding energy efficiency.
- Factory-wired single-point connection; blower starts/stops with the dishwasher pumps—no extra switches to remember.
- Purpose-built to bolt directly to CLeN Series conveyors; no field fabrication required.
Compatible CLeN conveyor models
Works with CL44eN, CLPS66eN, CLCS66eN, CL54eN, CLPS76eN, CLCS76eN, CL64eN, CLPS86eN and CLCS86eN dishwashers in a left-to-right configuration.
Technical specifications
Direction of travel | Left-to-Right |
---|---|
Electrical | 200-240 V, 50 Hz, 3-Phase • 4.5 A • 15 A min. supply circuit |
Blower motor | 2 H.P. direct-drive, splash-proof enclosure |
Steam consumption | 55 lb/hr @ 20 psi (max 25 psi) |
Exhaust requirement | 200 – 400 CFM; 4 in. × 16 in. vent with locking damper |
Chamber length | 33 in. (840 mm) |
Plumbing connections |
1 in. FPT steam supply ¾ in. FPT condensate return (bucket traps furnished) 1 in. FPT drain |
Materials | Full stainless-steel chamber, tank, legs and wrap-around enclosure |
Controller | Ambient-compensated solid-state overload protection (115 V control circuit) |
Installation & compliance
- Must be bolted to the wash chamber with included stainless hardware and sealed with supplied foam gasket.
- Canopy hoods cannot be used over the blower-dryer; follow Hobart exhaust guidelines.
- Electrical, steam and plumbing connections must meet all local codes and the latest NEC.
- UL-cUL and NSF listed when installed per Hobart specifications.
Important: This accessory is factory-configured for left-to-right operation and the stated electrical specification. Ordering the correct travel direction and voltage is critical—contact us before checkout if you need assistance.
Continuous product improvement is Hobart policy; specifications are subject to change without notice.