Hobart BDSLRAL-HTSDOM Warewash - Flow Undercounter Dishwashers
Hobart BDSLRAL-HTSDOM Warewash - Flow Undercounter Dishwashers is backordered and will ship as soon as it is back in stock.
Documents
Related Searches
Reach out via chat, email, or phone—we're here to help make sure it's the right fit for your kitchen. Contact us for more information.
Description
Hobart CLeN Steam Blower-Dryer – Left-to-Right, 200-240 V / 50 Hz / 3-Ph
High-velocity forced-air drying accessory for CLeN conveyor warewashersSlash rack turn-time and eliminate hand-drying. Mounted to the unload end of your Hobart CLeN dishmachine, this stainless-steel steam blower-dryer forces a curtain of heated air over every dish, tray and utensil, delivering dinner-ready results in a single pass while keeping noise and energy use low.
Why you’ll love it
- Rapid results – 33 inch chamber floods wares with high-velocity heated air for fast, spot-free drying.
- Quiet power – 2 HP direct-drive industrial blower maximises airflow with minimal sound.
- Steam-heated efficiency – room air passes through a double-row finned copper steam coil; no electric elements to burn out.
- Seamless integration – pre-drilled, gasket-sealed flange bolts directly to Hobart CLeN conveyor dishwashers.
- Smart operation – blower starts and stops automatically with the warewasher pump motors; no extra switches to remember.
- Operator safety – internal baffles keep heat inside the chamber and away from staff at the unload table.
- All-stainless construction – welded and bolted chassis, wrap-around panels, legs and adjustable feet stand up to chemicals and daily wash-downs.
- NSF-listed & UL-certified for peace of mind.
Key specifications
Orientation | Left-to-Right flow |
---|---|
Electrical | 200-240 V, 50 Hz, 3-phase | 4.5 A | 15 A min. supply circuit |
Blower Motor | 2 HP (direct drive), splash-proof enclosure |
Steam Requirement | 55 lb/hr @ 20 psi (max 25 psi) |
Chamber Length | 33 inches (840 mm) |
Exhaust | 200 – 400 CFM via 4 in × 16 in vent connection |
Plumbing Connections |
1" FPT steam supply ¾" FPT condensate return (bucket trap furnished) 1" FPT drain |
Mounting Height | Raises overall machine height approx. 17 ⅜ in (442 mm) |
Simple installation
- Single-point 3-phase electrical hookup.
- Pre-tapped bolt pattern matches CLeN exit chamber—no field drilling.
- Foam gasket supplied for a watertight seal between units.
- Integral controller powered by the warewasher’s 115 V control circuit—no separate starter required.
Specifications subject to change without notice. Always consult the installation manual and local codes before ordering or installing.