Free shipping on your first order over $5000 – use code TeamUSA at checkout!

Hobart  |  Warewash  |  SKU: BDERLFP-STDDOM

Hobart BDERLFP-STDDOM Warewash Undercounter Dishwashers

$16,273.18
Expected delivery date of , to your door
if ordered within hours and minutes
Not Shipping to ?
More Delivery Options

Documents

Reach out via chat, email, or phone—we're here to help make sure it's the right fit for your kitchen. Contact us for more information.

Description

Hobart CLeN All-Electric Blower-Dryer – 380 V, 60 Hz, 3 ph (Right-to-Left)

High-velocity heated-air drying for CLeN conveyor dishwashers

Finish every ware cycle bone-dry in a single pass. Designed exclusively for Hobart CLeN Series conveyor dishwashers, this factory-matched blower-dryer forces a curtain of heated air across the full chamber width—speeding turn-around time, saving labor, and keeping your unloading area dry and comfortable.

Key advantages

  • Stainless-steel 33 in (838 mm) drying chamber built to the same rugged standard as your CLeN washer.
  • 2 H.P. direct-drive industrial blower moves 200–400 CFM with remarkably low sound levels.
  • 10 kW Incoloy® electric heaters with thermostatic control and separate over-temperature protection.
  • Positive, downward air curtain plus internal baffles recirculate heat for maximum drying and minimal table splash.
  • Splash-proof, ventilated motor enclosure for long life in humid ware-wash environments.
  • Single-point electrical connection simplifies installation; blower automatically starts and stops with the dishwasher pumps.
  • Hobart “Dual-Drive” stainless pawl conveyor section already aligned for seamless mating to your CLeN washer.

At-a-glance specifications

Orientation Right-to-Left operation (R-L)
Compatible machines All Hobart CLeN Series conveyor dishwashers*
Chamber length 33 in / 838 mm
Blower motor 2 H.P. (direct drive) — 3-phase
Heat capacity 10 kW total (3 × 3.3 kW Incoloy elements)
Electrical rating 380 V / 60 Hz / 3 ph   |   17.8 A FLA
Minimum circuit ampacity 25 A
Maximum protective device 25 A
Exhaust requirement 4 in × 16 in duct, 200–400 CFM (no canopy hood)
Drain connection 1 in FPT in-tank drain
Added height above washer 17 3⁄8 in / 441 mm
Material & finish 18-gauge stainless steel, fully welded & bolted

Installation highlights

  • Ships ready to bolt directly to the wash chamber using supplied stainless hardware and foam-tape gasket.
  • Controller circuit (115 V) is powered from the dishwasher’s internal transformer—no separate control wiring required.
  • Vent stack must remain clear; canopy hoods cannot be used above the dryer section.
  • Adjustable stainless feet allow ±¾ in leveling to match the adjacent dishmachine.

*Fits CL44eN, CL54eN, CL64eN, CLPS/CLCS 66eN & 76eN, CLPS/CLCS 86eN conveyor models. Contact us for compatibility questions.

Features & Specs

Manufacturer

Hobart

Brand_name

Warewash

Specifications

Blower Dryer, Electric, R - L, 380v/60/3-ph, Standard Height, Domestic