Hobart CLeN Series All-Electric Blower-Dryer Accessory
Right-to-Left • 480 V / 60 Hz / 3-Phase • Standard Height • Domestic ModelGive your Hobart CLeN conveyor dishwasher the finishing touch it deserves. This all-electric blower-dryer forces high-velocity heated air across every rack, delivering fast, consistent drying while adding only 17-3/8 in. of height to the machine. Reduce hand-drying, boost throughput and keep tableware spotless—shift after shift.
Key Advantages
- 33 in. stainless-steel drying chamber built to Hobart’s legendary durability standards.
- 2 HP industrial direct-drive blower moves room air quietly yet powerfully through the heater and plenum.
- 10 kW Incoloy® electric heat (3 × 3.3 kW) with thermostatic control and independent over-temperature protection.
- Positive forced-air circulation dries trays, dishes and utensils without manual intervention.
- Locking 4 in. × 16 in. vent with damper; requires 200 – 400 CFM exhaust.
- Hobart “Dual-Drive” stainless-steel conveyor pawls ensure seamless integration with CLeN warewashers.
- Splash-proof, ventilated motor enclosure and solid-state, auto-reset overload protection for worry-free operation.
- Single-point electrical connection simplifies installation; blower runs only when the dishwasher is in cycle.
Technical Specifications
| Direction of operation | Right → Left (R-L) |
|---|---|
| Electrical rating | 480 V / 60 Hz / 3-phase |
| Rated amperage | 15.7 A |
| Minimum circuit ampacity | 20 A |
| Maximum over-current protection | 20 A |
| Heating capacity | 10 kW (Incoloy elements) |
| Blower motor | 2 HP, direct-drive, splash-proof |
| Chamber length | 33 in. |
| Vent connection | 4 in. × 16 in. stack, 400 CFM |
| Exhaust requirement | 200 – 400 CFM |
| Clearance above machine | 17-3/8 in. |
| Compatible dishwashers | CLeN conveyor models (CL44eN, CL54eN, CL64eN, CLPS/CLCS series, etc.) |
| Certifications | NSF, cULus |
Built for Seamless Integration
The blower-dryer bolts directly to the CLeN wash chamber using stainless hardware and a factory-supplied gasket, preserving the machine’s NSF-listed sanitation envelope. The blower controller is pre-wired to operate from the dishwasher’s motor circuit, so no additional control wiring is needed.
Need help confirming fit or electrical requirements? Contact your Hobart representative or visit the Hobart resource center at hobartcorp.com.
Contact Us
Reach out via chat, email, or phone—we're here to help make sure it's the right fit for your kitchen. Contact us for more information.