Hobart CLeN All-Electric Blower-Dryer Accessory
Model: Warewash | 200 V / 50 Hz / 3-Phase | Left-to-Right OperationGive every rack that leaves your CLeN conveyor dishwasher the bone-dry finish today’s food-service operations demand. This factory-matched blower-dryer attaches directly to the unload end of any Hobart CLeN Series warewasher and drives a blanket of high-velocity, heated air across the full width of the conveyor—dramatically reducing towel use, labour and re-spotting.
Why You’ll Love It
- 33″ long, all-stainless chamber built to the same rugged standard as your CLeN machine.
- 2 H.P. industrial, direct-drive blower delivers powerful airflow at a whisper-quiet level.
- 10 kW Incoloy® electric heat (3 × 3.3 kW elements) with thermostat and independent over-temperature safety.
- Positive forced-air circulation dries plates, trays, utensils and plastic ware without manual wiping.
- Down-draft design with internal deflector baffles keeps heat on the ware—not on the operator or discharge table.
- Single-point 3-phase electrical connection; blower automatically runs only when the dishwasher pumps run.
- Hobart “Dual Drive” stainless conveyor pawls mate directly to the warewasher—no height or plenum adjustments needed.
- NSF-, UL- and CE-listed accessory engineered exclusively for Hobart CLeN Series dishwashers.
Technical Specifications
| Direction of Travel | Left ➔ Right |
|---|---|
| Electrical | 200 V / 50 Hz / 3-Ph (single-point connection) |
| Rated Amperage | 33 A |
| Minimum Circuit Ampacity | 45 A |
| Maximum Protective Device | 45 A |
| Heating Capacity | 10 kW (3 × 3.3 kW Incoloy elements) |
| Blower Motor | 2 H.P., splash-proof enclosure |
| Exhaust Requirement | 200–400 CFM through 4″ × 16″ vent stack (locking damper included) |
| Chamber Length | 33″ (838 mm) |
| Overall Height Added | ≈ 17 ⅜″ (441 mm) above CLeN machine |
| Construction | 304 stainless steel chamber, tank & adjustable legs |
| Compatible Warewashers | All Hobart CLeN Series conveyor models |
Installation & Venting
- Accessory bolts directly to the dishwasher using the supplied stainless hardware and foam-seal gasket.
- A dedicated 4″ × 16″ duct providing 200–400 CFM must be installed—canopy hoods are not compatible.
- Drain connection: 1″ FPT in dryer tank.
- Electrical and plumbing must comply with all local codes.
As part of Hobart’s policy of continuous product improvement, specifications are subject to change without notice.
Contact Us
Reach out via chat, email, or phone—we're here to help make sure it's the right fit for your kitchen. Contact us for more information.